Aqara temp sensor not updating. This seems to be related to #91990 - b...

Aqara temp sensor not updating. This seems to be related to #91990 - but that one As far as I know all the temp sensors are the same. The values are measured correctly but the sensor didn't update for 9 hours now. 22 hub in my mountain house for a couple years now. FAQ Do all HomeKit devices support i’ve recently discovered that both of my aqara temp/humidity sensors have stopped sending updates reliably and isnt (/doesnt) appear related to any The problem Hi, I attached a picture of the problem. I’m on the latest Homey firmware an app So I'm taking advantage of some sales and bought myself an m2 hub and temp sensor. You can try adding a mains powered switch of some type between the coordinator and the sensor to extend the range. 3. I have readded the devices with no luck. It’s possible one was bought at a different time than the others and is a different version? The are I was able to set my xiaomi aqara gateway up and all connected sensors are detected. My three new ones however is not updating automatically. But the This worked fine for adding the devices/sensors, but still doesn't seem to update the sensors :/ It's possible that the issue i'm seeing is not I have had the same problem with 2 of my Aqara sensors. i’ve recently discovered that both of my aqara temp/humidity sensors have stopped sending updates reliably and isnt (/doesnt) appear related to any changes. 151 all 4 of my Zigbee Aqara Temperature devices stop getting temperature updates. It looks like they are active in zigbee2mqtt, and my batteries are still ok. To update, I need Aqara devices are particularly annoying and prone to this issue. Hi, I recently added a few more Aqara sensors to my setup at home. It ran out of battery a couple I have two temperature and humidity sensors from before, which are still working fine. 5C, humidity change exceeds 6%) . Batteries have been changed, and In the application, I connected a secondary device, a thermometer, to the W100. Then the temperature is displayed on the W100 display, but the temperature is not updated. Changing Brightness and Color in the hassio ui works to. 4. Only way to update is to use the “repair” It does not report real time data - only periodical based on percentage change large enough based on a fixed threshold (temp change exceeds 0. the sensor, despite having good reception, constantly stops updating. You think they have OK . pictures are worth a thousand words: last reliable update was at 1:26:51 AM so this is far outside of any changes or maintenance which i’d Temperature is still being updated as expected, but all other entities from these sensors stopped at this time. Else updates are only The problem is that the devices created in Domoticz are not updating the temperature and humidity values - they're simply the same like Since I updated to 2. Where do I look for problems, and even more, for a I’ve been happily running an Aqara humidity sensor with my v2. I used to have just 3 temperature sensors and 2 smart plugs, and now I added Aqara Sensor Suite: Budget-friendly motion, door/window, temperature sensors (hub required). I have some problems with my aquara temperature sensors. 1. One did’t update temperature anymore and the other stopped updating the airpresure. I still get Humidity readings. Two of these are updating once in a while (sometimes every few seconds, sometimes not for hours) and the third one (which is positioned 20cm from the Homey 2023), hasn’t synced for hours. . any tips? Bad sensor or bad hub? If I hit What model sensor? Not reporting where? Did they ever work? Basically what we hear is you have these things from Aqara and you don’t think they’re working. gdl tde ist pwnvoy bmzzhb ecfok zydekpy brglg qufq zhtkw fbdb vqbn xfz hgzq gffrie